#29Soto

New Construction

  • Building Type : Collective housing > 50m
  • Construction Year : 2017
  • Delivery year : 2017
  • Address 1 - street : Vicente Luis Garcera Lopez 31006 PAMPLONA, España
  • Climate zone : [Csa] Interior Mediterranean - Mild with dry, hot summer.

  • Net Floor Area : 2 250 m2
  • Construction/refurbishment cost : 3 150 356 €
  • Cost/m2 : 1400.16 €/m2

Proposed by :

Certifications :

  • Primary energy need :
    5.9 kWhpe/m2.year
    (Calculation method : RD: 47/2007 )
Energy consumption
Economical buildingBuilding
< 50A
A
51 à 90B
B
91 à 150C
C
151 à 230D
D
231 à 330E
E
331 à 450F
F
> 450G
G
Energy-intensive building

This is the first block of housing certified in Spain under the Passivhaus standard, and therefore has a demand for heating below 15kWh / m2a, and a heating load of 10W / m2. This implies that a floor of 75m2 will have a heating load of only 750W, so with a hair dryer there would be enough to heat two houses.

To achieve this the following principles have been applied:
1. Insulation: A continuous thermal envelope is projected on the exterior of the building, which is not interrupted on deck or on the ground floor. Exterior insulation minimizes thermal bridges.

2. Thermal bridges: all the construction details have been modeled with a thermal bridge calculation program, so that it can be guaranteed that at any point inside the building there will be at least 17ºC of temperature. The terraces have been disconnected from the interior structure, the slab being cut so that the insulation line can have continuity, and the blinds go outside to avoid sealing problems, and the pre-frame has had to be extended to place a rigid insulation block, so that the facade rock wool has continuity to the carpentry itself.

3. High-performance carpentry and glazing: A set consisting of a high-performance PVC profile with a UfAlta tightness: in all the houses a door-blowing test has been carried out, applying standards en13829 and ISO 9972, and criteria foreseen by the Passivhaus Institut. The average tightness was 0.40 renewals / hour, a figure well below the 0.6r / h required by the Passivhaus Institute for certification.

4. Ventilation with heat recovery: When you have worked exhaustively the sealing makes perfect sense to use a mechanical ventilation of double flow, with recovery of heat of high efficiency. This allows the air to be preheated in winter to 17-18 ° C, so the differential is only 3-4 ° C. With a simple flow would have to raise the temperature of the outdoor air from 0 ° C on a winter day to 21 ° C setpoint.

See more details about this project

 https://www.construible.es/2017/06/07/29-soto-primer-edificio-residencial-certificado-passivhaus-espana
 http://www.eitb.eus/es/noticias/sociedad/videos/detalle/4093676/el-primer-bloque-de-pisos-passivhaus-del-estado-estara-en-pamplona/
 http://www.noticiasdenavarra.com/2016/04/24/vecinos/pamplona/el-bloque-de-viviendas-con-mayor-ahorro-energetico
 https://simaexpo.com/candidatura/29-soto-1er-bloque-residencial-passivhaus-en-espana/
 https://www.construible.es/2017/06/07/29-soto-primer-edificio-residencial-certificado-passivhaus-espana

Data reliability

3rd part certified

Stakeholders

    Contractor

    Promociones Las Provincias

    Laura Valencia


    Construction Manager

    Construcciones Erro y Eugui

    Iñigo Eugui


    Designer

    VArquitectos

    Germán Velázquez

Contracting method

Lump-sum turnkey

Owner approach of sustainability

The objective was to get the project with the lowest possible heating demand, so as to be able to offer houses without energy mortgage. For this, the Passivhaus standard was proposed, which also offers many other advantages, such as maximum indoor air quality, avoid thermal bridges and therefore pathologies, maximum interior comfort, absence of noise thanks to high insulation and great air tightness, etc.

Architectural description

The architecture could not be seen in any case mortgaged by the constructive solutions of high energy efficiency. For this, VArquitectos has done an intense work during the drafting of the project in order to be able to provide thermally adequate solutions to the architectural requirements. The most notable case are the large terraces which do not compromise in absolute efficiency of the building, since they are outside the thermal envelope.

If you had to do it again?

Certain solutions implemented on site would be simplified.

Energy consumption

  • 5,90 kWhpe/m2.year
  • 24,20 kWhpe/m2.year
  • RD: 47/2007

  • 26,80 kWhfe/m2.year
  • Heating 6.60kWh / m2a
    ACS 17.76kWh / m2a
    Cooling 2.5kWh / m2a

    Demand for heating will be below 15kWh / m2a, as the Passivhaus certification proves.

Envelope performance

  • 0,17 W.m-2.K-1
  • The façade is composed of exterior to interior:
    Ventilated composite aluminum facade
    Thermal insulation of double density rock wool in 10cm
    Waterproof coating
    Half massive brick flagpole
    Cast
    Mineral wool 5cm
    Cardboard plaster partition

  • 0,34
  • EN 13829 - n50 » (en 1/h-1)

  • 0,40

Systems

GHG emissions

  • 5,60 KgCO2/m2/year
  • CTE

  • 75,00 year(s)

Indoor Air quality

    The quality of the indoor air is guaranteed through the double flow with heat recovery. The ppms will be stable between 500ppms and 1000ppms. When air is filtered, there will be no pollen, dust, pollution, etc.

Health & Comfort

    In the absence of thermal bridges and gradients, and with the correct ventilation provided, no internal condescension will occur, avoiding the appearance of pathologies, mold, etc. The comfort will therefore be maximum, with a stable temperature of 21ºC, with a minimum expenditure on heating. In addition the absence of noises will be almost total thanks to the tightness of the houses and their high isolation.

Product

    Zehnder Comfoair

    Zehnder

    Koldo Monreal

    HLK / Belüftung, Kühlung

    Mechanical system of double flow with recovery of heat. A recuperator has been placed per housing unit, with a star distribution.

    The houses are not yet in use, but on the pilot floor, customers are very surprised by the absence of smells, noises, etc.

Construction and exploitation costs

  • 2 800,00
  • 45 000,00
  • 100 000
  • 3 150 356

Energy bill

  • 5 600,00

Urban environment

Soto de Lezkairu is a neighborhood recently created in Pamplona. It is currently closed in more than 50%, and has all the services of a new neighborhood; Transport, bicycle lane, recreation areas and parks, pneumatic garbage collection, etc.

Land plot area

1 150,00 m2

Built-up area

45,00 %

Green space

180,00

Parking spaces

Two basement floors, with space for 44 parking spaces, 29 storage rooms and 4 places for motorcycle.

Building Environmental Quality

  • indoor air quality and health
  • acoustics
  • comfort (visual, olfactive, thermal)
  • energy efficiency
  • building process

Contest categories

Energía & Climas Temperados

Energía & Climas Temperados

Premio de los Usuarios

Premio de los Usuarios

Gran Premio de Construcción Sostenible

Gran Premio de Construcción Sostenible

Green Solutions Awards 2017 - Edificios



Other case studies

More

Contest

Green Solutions Awards 2017 - Edificios